Table of Contents
Advertisement
2 INSTALATION
2.1
Power Supply
The MO-480 is an equipment powered through the mains for its operation.
The MO-481 is powered through an AC Adapter.
2.1.1
Operation using the Mains Adapter
Connect the MO-480 to the mains through the AC voltage connector located on
the rear panel.
Check if the mains voltage is according to the equipment specifications.
2.1.2
Operation using the AC Adapter
Connect the AC power adapter to the module MO-481 through the power
connector on the rear panel.
Then connect the AC power adapter to the mains via the mains cord. Ensure that
your mains voltage is compatible with the adapter voltage.
2.2
Installation and Start-up
The MO-480 modulator is designed for use as a rack-mounted 19 inches device
(1U chassis). The MO-481 modulator it is in an open frame chassis and can be
used anywhere.
To start-up the MO-480, switch the main switch located in the rear panel to
position I (power on). To start-up the MO-481, just connect the AC adapter to
the mains. After a successfully start up, all LEDs of the MO-480 blink (except
power). When the equipment is connected to the mains, the POWER LED
remains lit.
September 2016
2-3
Advertisement
Table of Contents
