Electrical Power Source; Piping And Interconnect Diagrams; Ro Membrane Element(S) - Sea Recovery SRC Aqua Matic 700-1 Owner's Manual

Electrical Power Source

An electrical power source capable of delivering the required constant voltage and cycles during System start up
and operation. Please refer to the topic

Piping and Interconnect Diagrams

Please refer to the
configurations). In addition, diagrams depicting several pre-filtration configurations have been provided. Please
follow the steps below when installing your System.
1. Determine pre-filtration and post-filtration components that must be installed.
2. Locate the appropriate diagram (see
3. Connect the components based on the corresponding diagram.

RO Membrane Element(s)

Important: At times, Sea Recovery Corporation will ship an Aqua Matic RO Desalination System WITHOUT
an RO Membrane Element installed. This is for the purpose of accommodating ship builders who want to
install the System in advance of commissioning the ship.
To determine whether or not a RO Membrane Element has been installed, check the High Pressure Vessel(s) for
a RO Membrane Element Serial Number tag (illustrated below).
If the RO Membrane Element Serial Number tag is missing or does not contain a serial number and date, then the
RO Membrane Element(s) are not installed. If the RO Membrane Element(s) are not installed, and you wish to
install them at this time, then please contact Sea Recovery Corporation and supply us with your original Purchase
Order Number, your Sea Recovery Corporation Invoice Number, and your System s Serial Number.
Important: If the RO Membrane Element is not to be installed at this time, ensure that you leave a visible
note at the system controller and at the front of the control panel informing the end user that: The RO Membrane
Element(s) are not installed; to contact the factory for the RO Membrane Element(s); and DO NOT operate
the system without the RO Membrane Element(s) installed.
Caution: Extensive damage will occur if the system is operated without at least one RO Membrane Element
installed. Damage to the system caused by the operation of the system without RO Membrane Element will
be treated as follows:
• It will NOT be covered by the Sea Recovery Corporation warranty.
Electric Motor Specifications
Appendix on page 91 for diagrams (which include both standard and optional accessory
Appendix
on page 30 for details.
on page 91).
System Description
21