System Specifications; Installer-Supplied Components - Sea Recovery SRC Aqua Matic 700-1 Owner's Manual

System Specifications

Model
SRC Aqua Matic 450-1
SRC Aqua Matic 700-1
SRC Aqua Matic 900-1
SRC Aqua Matic 900-2
SRC Aqua Matic 1400-2
SRC Aqua Matic 1800-2
Specification
Salt rejection (Chloride Ion)
Product water temperature
Salinity monitoring
Salinity range of feed water
Temperature range
Feed water flow per hour
Reverse Osmosis (RO) membrane
Chlorine tolerance
pH range
Minimum feed water pressure
6 psi
Maximum feed water pressure
40 psi
Nominal operating pressure (seawater @ 35,000 PPM, 77°F / 25°C)
800 psi
External installation water connections (pip sizes to be supplied by the Installer for connection of the Sea
Recovery supplied components)
• Feed Inlet - ¾ in. (19 mm) MNPT Male National Pipe Thread U.S. Standard
• Brine Discharge - ¾ in. (19 mm) MNPT Male National Pipe Thread U.S. Standard
• Product - ½ in. (12.7 mm) FNPT Female National Pipe Thread U.S. Standard

Installer-supplied Components

The components described in this topic are to be supplied by the Installer, based on the criteria provided by Sea
Recovery Corporation.
Important: All fittings, valves and piping installed prior to, during, and after the Aqua Matic RO Desalination
System installation must not contain iron. Should iron fittings, valves and/or piping be installed, then the
resulting failure of the RO Membrane Element will be attributed to improper installation, and will be the liability
of the Installer.
Prod. Water per Hour
(U.S. Gallons / Liters)
19 / 71
29 / 110
38 / 142
38 / 142
58 / 221
75 / 284
Value
99.4%
Ambient to feed water temperature
Automatic computer controlled electronic monitoring. The salinity monitoring components of the
system give a continuous readout in micromhos per cubic centimeter, are temperature compensated
and of a fail-safe design.
Seawater up to 50,000 PPM TDS (NaCl) (typical seawater salinity is 35,000 PPM)
Maximum 122°F / 50°C, Minimum 33°F / 0.5°C
225 U.S. Gallons / 852 Liters (AC 50 Hz); 270 U.S. Gallons / 1022 Liters (AC 60 Hz)
Specifically selected High Rejection / High Yield aromatic tri-polyamide, thin film composite, spiral
wound, single pass Reverse Osmosis membrane element.
0.1 PPM
3-11 (typical seawater pH is 8)
0.42 kg/cm²
2.8 kg/cm²
56.25 kg/cm²
Prod. Water per 24 hours
(U.S. Gallons / Liters)
450 / 1703
700 / 2650
900 / 3407
900 / 3407
1400 / 5300
1800 / 6814
System Description
Weight
(lbs / kg)
153 / 69
156 / 71
158 / 72
165 / 75
171 / 76
176 / 80
41.4 kPa
275.8 kPa
5516 kPa
19