Physical Description; Front Panel; Figure 3-1: Front Panel; Table 3-1: Front Panel Description - AudioCodes Mediant 2000 Hardware Installation Manual

Hardware Installation Manual
3

Physical Description

The device's chassis is an industrial platform that is 19" wide, 1U high rack-mount and 12"
deep. The device houses a single blade in Slot #1 (the lower slot - form factor 6U PICMG
2.0 single slots) on the front panel. This blade is composed of one or two identical
modules: Gateway-1 and Gateway-2, each containing 240 DSP channels. These modules
are fully independent, each possessing its own Media Access Control (MAC) and IP
address, as well as LED indicators.
This section provides a physical description of the device's front (refer to 'Front Panel' on
page 11) and rear (refer to 'Rear Panel' on page 12) panels.
3.1

Front Panel

The front panel of the device is shown in the figure below and described in the subsequent
table:
Item #
1
2
3 FAIL & ACT
4
5 ETH (LINK &
6
Version 6.4

Figure 3-1: Front Panel

Table 3-1: Front Panel Description

Label
FAULT Dual AC power LED. The device's power supply is available in
one of the following configuration options:

Single universal 100-240 VAC, 1 A max, 50-60 Hz

Dual-redundant 100-240 VAC, 1.5 A max, 50-60 Hz

-48 VDC power supply suitable for field wiring applications
For more information on this LED, see Section
16.
- Blade locking screws
Status LEDs. For more information, see Section
14.
T1/E1 E1/T1 Trunk status LEDs (for each of the 1-8 trunks). For more
STATUS information on this LED, see Section
Ethernet LEDs. For more information on this LED, see Section
ACT) 3.3.3 on page
- Reset button
Note: This button is currently reserved for future use.
Component Description
15.
11
3. Physical Description
3.3.7 on page
3.3.1 on page
3.3.2 on page 14.
October 2011