After Installing Belt Cleaner; Cleaner Changing Belt Line; Cleaner With Belt Support - Martin DT2 Operator's Manual

After Installing Belt Cleaner

Belt Line
Figure 6a. Cleaner Changing Belt Line
Martin Engineering M3687-06/14
Read entire section before beginning work.
1. After belt cleaner and tensioner are installed, measure from pulley shaft
to mainframe on both operator side and far side to make sure mainframe
is parallel to pulley.
2. Measure from center point of pulley to outside edge of first and last blade
to make sure blades are centered on belt.
3. Make sure cleaner is not changing belt line (Figure 6a). If it is, install
belt support ahead of blade-to-belt contact point (Figure 6b).
4. Thoroughly wipe outside chute walls clean above tensioners on both sides
of chute. Place Conveyor Products Warning Labels (P/N 23395) on chute
walls or where they will be visible to belt cleaner operator.
Failure to remove tools from installation area and conveyor
belt before turning on energy source can cause serious injury
to personnel and damage to belt.
5. Remove all tools and fire retardant cover from installation area and
conveyor belt.
Do not touch or go near conveyor belt or conveyor accessories
when conveyor belt is running. Body or clothing can get
caught and pull body into conveyor belt, causing severe injury
or death.
6. Turn on conveyor belt for 1 hour.
13
IMPORTANT
Belt Line
Figure 6b. Cleaner with Belt Support
WARNING
!
DANGER
!
®
Martin DT2 Inline Cleaner