Table of Contents
Advertisement
Martin Engineering M3687-06/14
Before adjusting belt cleaner, turn off and lock out/tag out
energy source to conveyor belt and conveyor accessories.
7. After 1 hour of operation, turn off and lock out/tag out energy source
according to ANSI standards (see "References").
8. Make sure all fasteners are tight. Tighten if necessary.
9. Inspect belt cleaner for the following:
• Wear. (A small amount of "break-in" wear may be found.)
• Material buildup. (No material between blades and return side of
conveyor belt should be found.)
10. If wear, material buildup, or some other problem exists, see
"Troubleshooting/Installation Checklist."
14
WARNING
!
®
Martin
DT2 Inline Cleaner
Advertisement
Table of Contents
