Before Installing Belt Cleaner - Martin DT2 Operator's Manual

Before Installing Belt Cleaner

Martin Engineering M3687-06/14
1. Remove belt cleaner from shipping container. Equipment in container
should include the following:
®
• Martin DT2 Inline Cleaner (mainframe, tensioner, and blades).
• Two Conveyor Products Warning Labels, P/N 23395.
• Two Pinch Point Warning Labels, P/N 30528.
2. If anything is missing or damaged, contact Martin Engineering or a
representative. Keep any damaged goods subject to examination.
Before installing equipment, turn off and lock out/tag out
energy source to conveyor and conveyor accessories.
3. Turn off and lock out/tag out energy source according to ANSI standards
(see "References").
If equipment will be installed in an enclosed area, gas level or
dust content must be tested before using a cutting torch or
welding. Using a cutting torch or welding in an area with gas
or dust may cause an explosion.
4. If using a cutting torch or welding, test atmosphere for gas level or dust
content. Cover conveyor belt with fire retardant cover.
The chute wall that is easiest to access is referred to as the
"operator side." The other side of the chute is referred to as
the "far side."
5. Determine which side of chute is easiest to access. Locate the operator
side tensioner on the most accessible chute wall and the far side tensioner
on the other side of the chute.
3
WARNING
!
WARNING
!
NOTE
®
Martin DT2 Inline Cleaner