Installing Belt Cleaner; Locating Cleaner Centerline - Martin DT2 Operator's Manual

Inline cleaner

Hide thumbs Also See for DT2:

Table of Contents

Installing Belt Cleaner

Locating Cleaner

Centerline

Martin Engineering M3687-06/14

Read entire section before beginning work.

To install the belt cleaner, follow the procedures corresponding to the

following steps:

If installation is to be done in an enclosed area, test

atmosphere for gas level or dust content. Follow all welding

and safety guidelines. Protect belt surface from weld splatter

with appropriate shield.

For original equipment installation, where cleaner cutouts

and brackets have been fabricated into the chute during

construction, ignore steps 1, 2, and 3.

Solid backing of the blade is essential to ensure proper

operation and efficient cleaning. Install the cleaner adjacent to

the head pulley or a flat pressure roller to obtain best cleaning

results. See Figures 1a and 1b.

For installation on enclosed head pulley chutework, draw all

dimension lines on chute wall. In applications where head

pulley is not enclosed, use the best available field resources

and/or methods to ensure that these critical dimensions are

followed for a proper installation.

1. On the return side of the belt, locate the tangent point at which the belt

leaves the head pulley. Measure a distance 2.0 in. (51 mm) and draw a line

perpendicular to the belt at this point. See Figures 1a and 1b.

For installation below pressure rollers, mark the vertical line

2 in. (51 mm) from the centerline of the roller. See Figure 1a.

2. This line represents the centerline of the Martin

the cleaner mount brackets.

IMPORTANT

WARNING

NOTE

DT2 Inline Cleaner and

Martin

DT2 Inline Cleaner

Table of Contents