Figure 9 Mounting the NSW on a Rack (NSW100-28P, NSW100-28 and NSW200-28P)
Using a #2 Philips screwdriver, install the M5 flat head screws through the mounting bracket holes into
2
the rack.
Repeat steps
3
Note: Make sure you tighten all the four screws to prevent the NSW from getting slanted.
2.4 Wall Mounting (NSW100-10 only)
The next table summarizes wall mounting specifications.
Table 2 Wall Mounting Information
Distance between holes
Masonry Plug
3.5mm self-tapping screw
Do the following to attach your NSW to a wall.
Insecure mounting may damage the device or cause injury. ZyXEL is
not responsible for damages incurred by insecure wall-mounting.
Chapter 2 Hardware Installation and Connection
1
and
2
to attach the second mounting bracket on the other side of the rack.
135mm
two
two
NSW Series User's Guide
16