Table of Contents
Advertisement
2.3 Freestanding Installation Procedure
Make sure the Switch is clean and dry.
1
Remove the adhesive backing from the rubber feet.
2
Attach the rubber feet to each corner on the bottom of the Switch. These rubber feet help protect the
3
Switch from shock or vibration and ensure space between devices when stacking.
Figure 5 Attaching Rubber Feet
Set the Switch on a smooth, level surface strong enough to support the weight of the Switch and the
4
connected cables. Make sure there is a power outlet nearby.
Cautions:
• Avoid stacking fanless Switches to prevent overheating.
• Ensure enough clearance around the Switch to allow air circulation for cooling.
• Do NOT remove the rubber feet as it provides space for air circulation.
2.4 Wall Mounting
The Switch can be mounted on a wall (see
mounting on a concrete or brick wall.
Do the following to mount your Switch on a wall.
See
Table 6 on page 13
Table 6 Distance between the centers of the holes for wall mounting
MODEL
XMG-105HP
XMG-108
XMG-108HP
Chapter 2 Hardware Installation and Connection
for how far apart to place the screws.
DISTANCE
114 mm
188 mm
188 mm
XMG-100 Series User's Guide
Table 5 on page
12). You may need screw anchors if
13
Advertisement
Table of Contents
