Installation - Maico WR 410 Quick Start Manual

UK | Installation

10 Installation

10.1 Safety instructions
● Observe accident prevention
requirements. Generally have
2 people install the unit.
● Danger of injury when working
at height. Use appropriate, cer-
tified climbing aids (ladders).
● Danger of injury from falling
ventilation unit or hood (Trio
QD AR and QD AL): Ensure
that ventilation unit and hood
(Trio) are mounted perfectly.
Only install the ventilation unit
on a ceiling/wall with sufficient
load-bearing capacity (at least
200 kg/m³).
10.2 Removing/Fitting covers
310/410 320/470
Removing covers
1. Tilt front plate forwards at the two top
corners (magnets [M]) and remove from
above.
2. Release the 4 screws on the front cover
(bayonet closure) and remove front cover.
Note information on sticker.
46
Fitting covers
1. Place front cover in the bottom housing
rail, close and secure with 4 screws
(bayonet closure).
2. Fit front plate in the two lugs [L] and
close (magnets [M]).
170
Removing/fitting front cover
1. Loosen the two quick-release locks and
remove the front cover.
2. To lock, fit the front cover and secure with
the two quick-release locks.
Flat
Removing/fitting front cover
WARNING  Chapter 10.1
!
1. Mount front cover installation aid [M] (Fig.)
and fit locking bolt [S] opposite.
2. Remove the 8 screws that hold the front
cover in place.
3. Unscrew locking bolt [S] and take off front
cover.
4. To fit the front cover, proceed in reverse
order. Ensure that the cover is seated cor-
rectly and no false air can be drawn in.