Removing The Ocp Card - Dell E43S Series Installation And Service Manual

Figure 35. Installing the mezzanine card bridge board
Next steps
1 Install the mezzanine
2 Install the expansion card riser
3 Install the sled into the enclosure.
4 Follow the procedure listed in

Removing the OCP card

Prerequisites
NOTE: The procedure to remove the mezzanine blank is similar to the removal of a mezzanine card.
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the sled from the enclosure.
4 Remove the mezzanine
Steps
1 Push the blue retention clips away on one side and release the Open Compute Project (OCP) card.
Repeat step 1 to release the card from the clips on the other side.
2 Slide the card toward the front of the sled to disengage the connectors from the chassis and lift the card up.
78 Installing and removing system components
card.
assembly.
After working inside your
Safety instructions.
Before working inside your
card.
system.
system.