Figure 29. Installing the M.2 SATA x16 riser
Next steps
1
Install the sled
into the enclosure.
2
Follow the procedure listed in
Removing the M.2 SATA card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the sled
from the enclosure.
4
If applicable,
remove the expansion card riser
5
Remove the M.2 x16
Steps
1
Using the Phillips #1 screwdriver, unscrew the screw that secures the M.2 card to the board.
2
Pull the card out of the connector and lift the card away.
72
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
assembly.
riser.
system.
system.