Valve Box And Intake Pipe; Gearbox Output Pinion - SHERCO 250 SE/R Workshop Manual

REASSEMBLING THE ENGINE (next)

VALVE BOX AND INTAKE PIPE

• Place a new valve box gasket.
• Put the complete valve box in the intake
duct.
• Install a new intake pipe gasket.
• Assemble the intake pipe with the 4M6
screws.
• Install the intake sleeve with its metal collar.

GEARBOX OUTPUT PINION

• Oil the o-ring and thread it onto the output
shaft.
• Thread over the spacer so that the gasket
sits in place.
• Place the gearbox output pinion, the safety
washer.
• Put blue threadlock on the thread.
• Thread the safety washer.
• Fix the nut to tighten to 150Nm.
• Unfold the safety washer's tab onto the
nut.
STARTER DRIVE ASSEMBLY
• Put the double pinion in the needle cage.
• Put the starter drive in place.
• Position the retaining triangle and fix the
3 THEP screws.
• Lubricate the pinions with grease spray.
40
250-300 SE-R