Gear Selection Mechanism - SHERCO 250 SE/R Workshop Manual

REASSEMBLING THE ENGINE (next)
GEAR SELECTION
MECHANISM
• Put the spring in the crankcase with the
strand bent upwards.
• Thread the spacer, the locking pin.
• the washer, coat the CHC M6X20 screw
with blue threadlock and assemble all
parts.
• Attach the spring to the lever. The other
end of the spring must be pressed against
the housing.
• Fit the star selector's indexing pin onto the
drum.
• Pull the lock lever back to position the star
selector.
• Coat the screw with blue threadlock and
assemble the star selector on the drum.
• Grease the already assembled selection
pin and thread it into the needle bearings
without forgetting the lock washer.
• When the prong stops against the star
selector push it back so that the shaft can
be lowered completely.
34
250-300 SE-R