SHERCO 250 SE/R Workshop Manual page 56

DIAGNOSTIC TOOL (next)
E - Updating the controller
It is possible to update the injection mapping (calibration) with the diagnostic tool. This could
be for a Racing muffler, for example, or because an update is proposed by the factory.
These files will be freely available on sherconetwork (from the end of 2013).
Pay attention to the vintage, the engine capacity, the type of silencer, etc.
If in doubt, contact your technical support.
1 - Download the desired update (file.word)
2 - Switch on the motorcycle
3 - Click on controller update
Confirm with the icon
Select the previously downloaded calibration file (.word) and click on open.
4 - The file is being downloaded
WARNING !
Do not switch off the motorbike during the download operation (flash) do not suddenly turn off the
software during the flash. The controller could be irremediably damaged.
56
250-300 SE-R