Belling IH302T User Manual page 16

Specific Failure & Solution
Failure
The LED does not
come on when
unit is plugged in.
Some buttons
can't work, or the
LED display is not
normal.
The Cooking
Mode Indicator
comes on, but
heating does not
start
Heating stops
suddenly
during operation
and the display
flashes "u".
Fan motor sounds
abnormal.
Problem
No power supplied.
Request a service
visit from an
Engineer to check
the connection
between the power
board and display
board.
The accessorial
power board is
damaged.
The display board is
damaged.
The display board is
damaged.
High temperature of
the hob.
There is something
wrong with the fan.
The power board is
damaged.
Pan Type is wrong.
Pan diameter is too
small.
Hob has overheat-
ed.
Request a service
visit.
Solution A
Check that appliance is
switched on at the fused spur
cooker point on the wall.
Check the connection.
Replace the accessorial
power board.
Replace the display board.
Request a service visit.
Switch the hob off and let it
cool down.
Check the installation to
ensure that the air inlets and
outlets are not blocked.
Check whether the fan runs
smoothly; if not, replace the
fan.
Replace the power board.
Use the proper pan (refer to
the instruction manual.)
Unit is overheated. Wait for
temperature to return to
normal.
Push "ON/OFF" button to
restart unit.
Replace the fan.
16
Solution B
Pan detection circuit is
damaged, replace the
power board.