Advertisement
D
ESCRIPTION OF THE
Your new Vibratory Tumbler will be useful for a wide variety of finishing
operations. The following are a few suggestions:
• Removing rust from pieces of hardware without losing details of rounded edges.
• Removing burrs from hardware and stampings.
• Polishing difficult to reach surfaces to a high shine.
• Rapid parts degreasing using Eastwood Metal Wash (10120).
IMPORTANT HEALTH AND SAFETY CAUTIONS
Please read all information and follow directions carefully.
• DO NOT cover the machine with anything (such as a blanket or a box)
to dampen the noise as this could cause overheating and become a
potential fire hazard.
• DO NOT use any solvents in the tumbler bowls.
• Always connect the machine to a power source that has been
properly grounded to prevent any possible electrical shock.
• Your tumbler is designed not to "walk" during normal operation.
We recommend that the machine be placed on a solid floor away from
moisture and combustible materials. If the machine is used on a bench,
it should be blocked in to prevent any accidents.
• Never attempt to operate or experiment with other than recommended media
and compounds.
For technical assistance, phone: 1-866-759-2131
2
For technical assistance e-mail: techelp@eastwood.com
P
RODUCT
Your Jumbo Vibratory Tumbler System (#21630)
includes the following:
• Tumbler Base with coil spring suspension with
adjustable agitation counterweight
• #21631 22" Tumbler bowl and lid assembly
• All necessary bowl attachment hardware
• Complete instructions
G
ENERAL
Your Jumbo Tumbler System has been supplied with 1 general-purpose bowl
used for wet and dry polishing operations. The bowl may be used with our full
range of tumbler media.
To install the bowl, place it over the threaded stud in the base, place rubber
faced washer over stud and gently tighten nut. Make sure the bowl gasket is
seated. Install the lid, the large metal washer, and tighten the large wing nut
properly so that the lid will not vibrate loose.
The working capacity of the Large Tumbler System is approximately 50 pounds.
The capacity includes both the media and the work pieces.
To order parts and supplies, call 1-800-345-1178 or www.eastwood.com
C
ONTENTS
I
NSTRUCTIONS
3
Advertisement
