Hardware Installation; Mounting The Device; Installing/Removing From A Din Rail - Advantech SMARTSWARM 300 Series User Manual

SmartSwarm 342
:

3. HARDWARE INSTALLATION

3.1 MOUNTING THE DEVICE

The unit may be mounted in any orientation. It can simply be placed on a flat surface or it can be DIN rail mounted
using the supplied CKD2 holder.

3.1.1 INSTALLING/REMOVING FROM A DIN RAIL

The CKD2 holder, which is used for mounting the gateway on a DIN rail, should be mounted such that the smaller
flange on the holder is at the top when the unit is mounted on a DIN rail.
Default Orientation of the CKD2 Holder
To insert into a DIN rail, hook the lower (longer) flange into the DIN rail then rotate the top of the unit towards the
DIN rail until it clicks into place. To remove from the DIN rail, lightly push the IoT gateway upwards until the top
part of the CKD2 holder clears the top of the DIN rail. The top of the gateway can then be pulled away from the
DIN rail, which will in turn release the lower DIN connection point.
18