Replacing The Bulbs; Troubleshooting - Specialized FireBalls Comp Manual

REPLACING THE BULBS

Always remove the battery pack from the electronics housing before servicing your
FireBalls Comp. Replacement bulbs are available from your local Specialized dealer.
To remove one of the bulbs, unscrew the bezel on the front of the lamp housing by
rotating it counterclockwise. Carefully pry the bulb out of the housing with the tip of a
small screwdriver. Replace the blown bulb with one of identical size, voltage and
wattage. Insert the new bulb. Be careful to align the pins on the bulb with the holes
inside the lamp housing. Re-install the bezel by rotating it clockwise.

TROUBLESHOOTING

Light doesn't turn on.
• Make sure your battery is fully charged. Push the button on the battery pack
and note how many of the lights on the fuel gauge illuminate. If no LEDs turn on
you need to charge the battery.
• Check the batteries in your handlebar transmitter. Does the backlight in the trans-
mitter turn on when you push one of the buttons? If not, replace the batteries.
• Is your FireBalls Comp programmed to your transmitter code? Follow the instructions
under the section titled "Wireless Transmitter"
• Is one or both of your bulbs blown? Replace the questionable bulb with
a known-good one.
Battery won't charge
• Is your battery pack hot? Allow the pack to cool. The charger will automatically
begin the charge process as soon as the pack cools.
• Is the transformer plugged into the wall and into the charger base?
• Is there power at the wall outlet into which the transformer is plugged?
IMPORTANT!
• Pay attention to traffic and road conditions at all times. Your first obligation is
to be attentive and to ride safely.
• During use, the housing will become quite hot. Use caution not to touch the lamp
housing while the lamp is on.
• Never put your FireBalls light away hot. Always allow the lamp housing to cool
before placing it in the storage case.
• In cold weather (below 50ªF or 10ªC) the capacity of your battery pack may be
reduced. Plan your ride accordingly.
• Do not submerge your FireBalls under water. It is designed to be water-resistant,
not waterproof.
• Do not drop your FireBalls light. Dropping it can cause it to fail prematurely.
• Do not disassemble your FireBalls lighting system.
• Keep the lights and all of their components tightly attached, and check them
regularly. If any of the components loosen, it could become tangled in your spokes
and cause an accident.
• See your authorized Specialized dealer if you have any trouble installing or
maintaining your lights.
• Clean the unit with a mild detergent and a soft dry cloth. Never use any kind
of solvent or alcohol.
• The FireBalls Comp is intended for use on bicycles only and should not be
used on any motorized vehicle.
• Never look directly into the light beam.
5