Grandstream Networks HT818 User Manual page 20

02 "IP Address " + IP address
03 "Subnet " + IP address
04 "Gateway " + IP address
05 "DNS Server " + IP address
07 Preferred Vocoder
10 "MAC Address"
12 WAN Port Web Access
13 Firmware Server IP Address
14 Configuration Server IP
Address
15 Upgrade Protocol
16 Firmware Version
17 Firmware Upgrade
47 "Direct IP Calling"
The current WAN IP address is announced
If using "Static IP Mode", enter 12 digit new IP address.
You need to reboot your HT818 for the new IP
address to take Effect.
Same as menu 02
Same as menu 02
Same as menu 02
Press "9" to move to the next selection in the list:
•
PCM U / PCM A
•
iLBC
•
G-726
•
G-723
•
G-729
•
OPUS
•
G722
Announces the MAC address of the unit.
Note: The device has two MAC addresses. One for the
WAN port and one for the LAN port. The device MAC
address announced is the address of LAN port.
Press "9" to toggle between enable / disable.
Default is disabled.
Announces current Firmware Server IP address. Enter
12-digit new IP address.
Announces current Config Server Path IP address.
Enter 12-digit new IP address.
Upgrade protocol for firmware and configuration update.
Press "9" to toggle between TFTP / HTTP / HTTPS /
FTP / FTPS
Announces Firmware version information.
Firmware upgrade mode. Press "9" to toggle among the
following three options:
•
Always check
•
Check when pre/suffix changes
•
Never upgrade
Enter the target IP address to make a direct IP call, after
HT818 User Guide
Version 1.0.10.6
P a g e |
19