Table of Contents
Advertisement
S
6.1 Trouble Conditions
The control panel always watches for possible trouble
conditions. If a trouble condition occurs, the keypad
"Trouble" light will turn on and the keypad will beep.
Press [ ][2] to display the trouble conditions.
The following trouble conditions apply to the
receiver portion (identified as the PC5132 by the
panel) and/or any enrolled devices. For a
description of all troubles, please see your system
Installation Manual.
• General System Tamper
• General System Supervisory
• Zone Fault
• Device Low Battery
• Zone Tamper
Wireless Zone Low Battery
Transmission
Within the supervisory transmission, the device will
indicate the status of the battery. If a battery is low,
the system will indicate a Device Low Battery trouble.
NOTE: Since the WLS908 does not send supervisory
transmissions, a low battery on this device will not
cause a Device Low Battery trouble. The user should
be instructed to test this device every week. See
section 5.4 for testing instructions.
The system will delay reporting the event to the
central station for the number of days programmed
for Zone Low Battery Transmission Delay in section
[370]. This will prevent unnecessary reporting of the
event if the user has been instructed on how to
replace batteries.
Additional Notes
E
C
T
I
O
N
6.2 Replacing Batteries in Wireless
Devices
1 Remove the cover of the device from its back
plate. This creates a tamper condition on the zone.
2 Refer to the battery installation instructions on the
installation sheet of each component. Be sure to
note the proper orientation of the batteries as you
install them.
3 When the fresh batteries are in place, re-attach
the cover to the back plate. The tamper is restored
and the zone sends a battery trouble restoral signal
to the receiver. The battery trouble is now clear
and the device should function normally.
NOTE: When batteries in one device need to be
replaced, the batteries in all devices should be
replaced at the same time.
15
6
Advertisement
Table of Contents
