Daily Inspection Checklist - Labounty CP 80 Safety, Operation & Maintenance Manual

CONCRETE PULVERIZERS
Attachment Model _____________________Excavator Hour Meter________________________
Attachment Serial Number ______________________________ Date______________________
_______ 1. Visually inspect attachment for any damage.
_______ a. Check for cracks or excessive wear that may cause structural failure
_______ 2. Inspect the Swift-Lock teeth and tooth seats.
_______ a. Check for excessive looseness or damage. It is acceptable for the teeth to move
_______ b. Check the tooth pins for damage or looseness
_______ c. If necessary, rework or replace the teeth as outlined in this manual
_______ 3. Inspect all bolts.
_______ a. Visually inspect all bolts and replace any that are loose or damaged
_______ 4. Inspect pins and pin retaining hardware.
_______ a. Main pivot pin
_______ b. Link pin
_______ c. Position arm pins (both ends)
_______ 5. Grease all points until excess appears. Use premium grease no. 2EP or equivalent.
_______ a. Link pin connection in upper jaw lugs
_______ b. Main pin connection in upper jaw lugs
_______ c. Main pivot in stationary jaw
_______ d. Position arm ends
_______ e. End of link pin and main (if required)
_______ f. Check excavator for grease fi ttings at other connections
Inspected by: __________________________________________________________________________
Page 4 Section 5 Maintenance

DAILY INSPECTION CHECKLIST

slightly from side to side on on their seats