Periodic Service Schedule - Labounty CP 80 Safety, Operation & Maintenance Manual

PERIODIC SERVICE
SCHEDULE
SERVICE THE ATTACHMENT AT
SPECIFIED INTERVALS
Inspect, lubricate, make service checks and
adjustments according to the Daily Inspection
Checklist reproduced from this manual. A program
of regular service should be established, using
the machine hour meter to determine when the
attachment should be serviced. Use the intervals
on the Service Schedule when operating in normal
conditions. Service the attachment at shorter
intervals when operating in extreme environmental
or abrasive conditions. Use correct lubricants
and bolt torques. Refer to the lubrication and bolt
torque instructions in this manual when performing
maintenance on the attachment.
CONCRETE PULVERIZERS
DAILY SERVICE REQUIRED
Bolts: Check for looseness or damage.
Retorque if necessary. Refer to Bolt Torque tables
in this manual. Bolts may be retorqued once, then
must be replaced.
Connecting Pins and Pin Retaining Bolts: Inspect
for looseness, damage and/or wear on main pivot
pin and linkage pin. Check pinheads
and pinstops.
Grease Fittings: Lubricate according to the
instructions in this section. Replace broken fi ttings.
Swift Lock Teeth and Tooth Seats: Make sure all
tooth pins are in place. Inspect for wear indicating
build-up or hardsurfacing is required. Rotate
or replace if necessary. Refer to page 5-6 for
instructions.
Maintenance Section 5 Page 3