Turning On The Terminal - Hypercom SmartICE Hardware And Installation Manual

Turning On the Terminal

The SmartICE terminal operates using a +12 Vdc power cable in conjunction with a 110-Volt
grounded power receptacle.
Step-by-Step
To turn on the smartICE terminal:
1. Connect the +12 Vdc power cable from the AC adapter to the terminal power socket labeled
PWR .
2. Plug the adapter into a 110-Volt grounded power receptacle. Be sure the connector is firmly
seated. When the power is connected successfully, the terminal beeps twice and then
performs a self-test and diagnostic routine.
W
ARNING
Do not use an adapter, a power extender adapter, a power extender cable, or an AC outlet that
does not have a ground connection.
Do not disassemble the AC adapter. Only qualified service personnel should service the adapter.
The AC adapter was designed for indoor use only. Do not expose to rain or snow.
Do not immerse in fluid.
The reliability of electronic equipment is significantly reduced whenever it is powered from an
underground outlet. A low-power AC adapter connects power to the terminal. Connect only one
terminal to the AC adapter.
940264-001 Hypercom Corporation
Equipment Installation
2-3