References; Safety; Materials Required; Urethane Shelf Life - Martin DT2 Operator's Manual

References

Safety

Materials
Required
Urethane Shelf
Life
14
Martin Engineering M3699-03/16
The following documents are referenced in this manual:
• American National Standards Institute (ANSI) z244.1-1982, American
National Standard for Personnel Protection - Lockout/Tagout of Energy
Sources - Minimum Safety Requirements, American National Standards
Institute, Inc., 1430 Broadway, New York, NY 10018.
• Federal Register, Volume 54, Number 169, Part IV, 29 CFR Part 1910,
Control of Hazardous Energy Source (Lockout/Tagout); Final Rule,
Department of Labor, Occupational Safety and Health Administration
(OSHA), 32nd Floor, Room 3244, 230 South Dearborn Street,
Chicago, IL 60604.
®
• Martin Inspection Door Operator's Manual, P/N M3891.
All safety rules defined in the above documents and all owner/employer safety
rules must be strictly followed when working on the belt cleaner.
Only standard hand tools are required to install and service this equipment.
Urethane put in service after exceeding it's shelf life may wear
differently and deteriorate quicker than normal urethane.
Code Date is written near bottom of blade as mm/dd/yy-x. In
addition to or in place of this date, you may see an imprinted
date medallion similar to the example shown. In this example,
"14" stands for the year 2014. The small circles represent the
quarter of the year. If three circles are "punched" the blade
was produced in the first quarter. If none of the circles are
"punched" the blade was produced in the fourth quarter. If
code date on your blade(s) is not legible or is missing, contact
Martin Engineering or a representative.
Table I. Urethane Shelf Life
Blade Color
Blue
Brown
Clear
Green
Orange
2
IMPORTANT
NOTE
Shelf Life
1 Year from Code Date
2 Years from Code Date
1 Year from Code Date
2 Years from Code Date
1 Year from Code Date
®
Martin DT2 Inline Cleaner XHD