Martin Engineering M3699-03/16
Before installing, servicing, or adjusting the belt cleaner, turn
off and lockout / tagout / blockout / testout all energy sources
to the conveyor and conveyor accessories according to ANSI
standards. Failure to do so could result in serious injury or
death.
7. After 1 hour of operation, turn off and lockout / tagout / blockout / testout
energy source according to ANSI standards (see "References").
8. Make sure all fasteners are tight. Tighten if necessary.
9. Inspect belt cleaner for the following:
• Wear. (A small amount of "break-in" wear may be found.)
• Material buildup. (No material between blades and return side of
conveyor belt should be found.)
10. If wear, material buildup, or some other problem exists, see
"Troubleshooting/Installation Checklist."
17
DANGER
!
Martin
®
DT2 Inline Cleaner XHD