Introduction; General; Installations Without Chutework; Belt Cleaner Inspection Access - Martin QC1 Operator's Manual

Introduction

General

Installations
without chutework
Belt cleaner
inspection access

Belt cleaner blades

References

Martin Engineering M3722-11/12
To introduce product back into the product flow, a Pre-Cleaner is installed on
the face of the head pulley. On a dual cleaner system, the Secondary Cleaner
is installed immediately following the Pre-Cleaner to remove stubborn
material left on the conveyor belt. If a Pre-Cleaner cannot be used because of
space limitations, the Secondary Cleaner is installed alone. If the material-
handling process or product could be affected by contamination from the use
of these belt cleaners, the user is responsible for taking the necessary steps to
prevent contamination. Consult Martin Engineering or a representative for
alternate belt cleaners or belt cleaner locations to use where contamination
may be an issue.
These procedures were written for equipment that is being installed on
enclosed pulley chutework. If the pulley is not enclosed, the equipment should
be installed using the best available field resources and methods to ensure that
the critical dimensions are followed for proper installation.
If the belt cleaner is installed on enclosed pulley chutework, a Martin
Inspection Door should be installed. Martin
from Martin Engineering or a representative. See "Part Numbers" for a list of
®
Martin Inspection Doors and part numbers.
®
Martin QC™ Pre-Cleaner with Metal Tipped Blade should
NOT be used on belts with mechanical fasteners. It is intended
to be used only on Vulcanized Belts. When used on belts with
mechanical fasteners, damage may occur to both the belt and
the cleaner assembly. The cleaner should NOT be used on a
belt that contains gouges, holes, or other belt imperfections, as
the cleaner may cause further damage to the belt.
The following documents are referenced in this manual:
• American National Standards Institute (ANSI) z244.1-1982, American
National Standard for Personnel Protection - Lockout/Tagout of Energy
Sources - Minimum Safety Requirements, American National Standards
Institute Inc., 1430 Broadway, New York, NY 10018.
• Federal Register, Volume 54, Number 169, Part IV, 29 CFR Part 1910,
Control of Hazardous Energy Source (Lockout/Tagout); Final Rule,
Department of Labor, Occupational Safety and Health Administration
(OSHA), 32nd Floor, Room 3244, 230 South Dearborn Street,
Chicago, IL 60604.
1
®
Inspection Doors are available
CAUTION
!
®
Martin QC1™ Cleaner XHD with Metal Tipped Blade
®