Martin DT2 Operator's Manual page 8

Martin Engineering M3699-03/16
If equipment will be installed in an enclosed area, gas level or
dust content must be tested before using a cutting torch or
welding. Using a cutting torch or welding in an area with gas
or dust may cause an explosion.
5. If using a cutting torch or welding, test atmosphere for gas level or dust
content. Cover conveyor belt with fire retardant cover.
The chute wall where the tensioner with hitch pin will be
located is referred to as the "operator side." The other side of
the chute is referred to as the "far side."
6. Determine which side of chute is easiest to access. Locate the tensioner
on the most accessible chute wall.
4
WARNING
!
NOTE
Martin
®
DT2 Inline Cleaner XHD