Wayne EH User Manual page 31

Open the ignition device mounting plate and turn on the electrical breaker.
Next, bleed the pump by following steps 1-3 before starting the burner. See Figure 22 for the location of the bleeder valve
on the pump.
Bleeder Valve
Figure 22– Fuel Pump Bleeder Valve Location
Note: If the pump is set up in two pipe operation with the by-pass plug installed, bleeding the pump is not necessary.
1. Slide a 1/8" Vinyl hose on the bleeder valve as shown in Figure 23 and route the hose into a small container
Figure 23– Bleeder hose location
31