Wayne EH User Manual page 24

3. Next loosen the ignition device mounting plate clip screw by using a flat head screwdriver, move the hold down clip off
of the mounting plate, this will allow the igniter device assembly to swing open to the left. For now leave the plate in
the closed position (Figure 9).
Hold
down
clip
Motor
Flange
4. Using a 9/16 inch wrench loosen and remove the oil gun assembly locknut (Figure 10).
Figure 9 EH/EHASR Ignitor mounting plate screw removal
Figure 10 EH/EHASR Oil Gun Lock Nut Removal
24
Hold
down
clip