Table of Contents
Advertisement
Settings Mode & Factory Reset
Factory Reset
To return the unit to the factory-shipped state, you can perform a factory reset by following these instructions:
•
Press and hold both channels' (left and right) LOW THD switches during the power-up sequence.
•
When the switches in the centre of the unit start flashing RED, release the LOW THD switches and the unit will reboot
automatically with factory settings restored.
Press and hold both LOW THD switches during boot until central switches start flashing,
Be sure to release the LOW THD switches soon after the central switches start flashing red, or else you might
accidentally perform a Deep Factory Reset (see bottom of this page for more information).
Settings affected by Factory Reset:
•
Switches states
•
Shaft switches states
•
Frequency and Range settings for LF/HF/HF BELL
•
Brightness (default: 5th level over 8 total)
•
Relay feedback (default: ON)
•
Input trim (default: 0 dB)
•
Autosleep On/Off (default: Off)
•
Autosleep timeout (default: 20 min)
•
LPF (default: disabled)
•
Parallel Mix mode (default: disabled)
•
Side Solo mode (default: in-phase)
•
Right-hand side Meter On/Off in Stereo Mode (default: Off)
Deep Factory Reset
The Bus+ offers a 'Deep' Factory Reset, which is the same as the standard Factory Reset described above but it also resets the
Transient Expander to be unavailable/locked out. To unlock the Transient expander, you must once again win the built-in 'Code-
Break Master' game.
To perform a 'Deep Factory Reset', perform the same actions described for the standard Factory Reset but keep the switches
held for a few seconds longer, until the central switches start flashing GREEN, then release the LOW THD switches and the unit
will reboot automatically.
Please note that performing a Deep Factory Reset means that you will have to win a game of 'Code Break Master'
24
once more to unlock and be able to use the Transient Expander feature.
then release.
THE BUS+ User Guide
Advertisement
Table of Contents
