RoboLabs ROBOJETFLOSS ACB-09-120 Operation Manual page 12

COTTON CANDY MACHINE ACB-09-120 rev 11-May-18
'Cold start' Procedure
When the Robo JetFloss has been off for more than 15 minutes, it will take
at least 60 seconds before the heating coil has warmed enough for the
production of cotton candy to begin. If the machine has only been off for a
brief time, such as to add more flossugar, this time will be reduced
substantially.
Users of the 'Pro' version can press and hold the 'Quick start' button (15)
for 10 - 15 seconds. This will send full power to the heating element and
can be done whether the main power switch is on or not. This will
substantially reduce the time required to begin candy production.
Owners of the standard version can achieve a similar result by manually
adjusting the voltage regulator. After switching on both the motor (11) and
heating element (12), an experienced operator can adjust the voltage
regulator to the maximum (13). But, again for only 10 – 15 seconds, and
then decreasing the voltage back to the recommended operating range
between 70-80 V and proceeding as normal from there.
However, in neither case above should maximum voltage be applied for
more than 10 -15 seconds as you risk overheating the element and burning
12