Table of Contents
Advertisement
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
The Model G0836 comes nearly fully assembled
from the factory; however, the handwheel handles
were mounted internally for shipping. Before use,
reverse position of handwheel handles, as shown
in Figure 13.
Y-Axis
Handwheel
Figure 13. Handwheel handles installed
correctly.
-18-
Handwheel
Handle
Mounting
Location
X-Axis
Handwheel
Joining Drill Chuck
& Arbor
An arbor is included for the drill chuck that
comes with this machine. The following procedure
describes how to install the arbor in the chuck.
After the arbor is installed in the drill chuck, it
is very difficult to separate the assembly. If you
would like to use a different chuck in the future,
we recommend obtaining a new arbor.
Important: DO NOT install the drill chuck
and arbor assembly into the spindle until AFTER
the test run.
To join drill chuck and arbor:
1.
Use acetone or lacquer thinner to clean drill
chuck and arbor mating surfaces, especially
the bore.
2.
Retract chuck jaws completely into chuck.
3.
Insert small end of arbor into chuck.
4.
Hold assembly by the arbor and tap chuck
onto a block of wood with medium force, as
illustrated below.
Figure 14. Tapping drill chuck/arbor on block of
wood.
5.
Attempt to separate drill chuck and arbor by
hand —if they separate, repeat Steps 3–4.
Model G0836 (Mfd. Since 09/17)
Advertisement
Table of Contents
