Allen-Bradley 1756-HYD02 User Manual page 124

Chapter 4 Geometries with orientation support
124
•
Start with the frame coincident with a known reference frame {A}.
•
Rotate {B} first about X
•
then about Y by an angle Ry,
A
•
and, finally, about Z
Each of the three rotations takes place about an axis in the fixed reference frame
{A}. We call this convention for specifying the orientation X-Y-Z fixed angle. The
word fixed refers to the fact that the rotations are specified about the fixed
reference frame {A} as shown below.
Important: The Logix firmware uses this convention for specifying the points. Any
point in Cartesian space is specified by 6 numbers XYZRxRyRz where Rx, Ry
and Rz are specified with fixed angle convention.
Start with a frame coincident with reference frame {A}. First rotate {B} about Xa
by an angle γ, then rotate about Ya by an angle β and then rotate about Za by an
angle α. It is also important to note that order of rotation is important which in
this case is X-Y-Z. If this order is changed then orientation will get altered. This
fact is shown in the equation below.
R(γ ,β,α) = R (α)R (β) R
A
B Z Y
Euler Angle - Z - Y' - X"
Another possible convention of a frame {B} is as follows
•
Start with the frame coincident with a known reference frame {A}.
•
Rotate {B} first about Z
•
then about Y ' by an angle Ry,
B
Rockwell Automation Publication MOTION-UM002F-EN-P - February 2018
by an angle Rx,
A
by an angle Rz.
A
(γ)
X
by an angle Rz,
B