Table of Contents
Advertisement
R
2.3.2
Configure the Subscriber Stations
a.
Select Wireless Configuration and ensure that the Frequency and Channel Size are configured the same
on all linked radios.
b.
Change the Tx Power, if necessary.
c.
Select Apply & Save All.
d.
Select System Configuration and ensure that each radio has a unique IP address so that they can be
individually accessible over the wireless link.
e.
Change the IP Address.
f.
Select Apply & Save All.
g.
Perform the Wireless Configuration and System Configuration for all other SS radios in the system,
recording each radio's MAC address if using Normal Links as they will be needed when configuring the
SC radio. Otherwise, ensure that the STID and STID Password match those of the SC radio if using Link
Templates.
2.3.3
Configure the Sector Controller
a.
Select Wireless Configuration.
b.
Observe that only one of the radios in the system should be configured as a Sector Controller (SC).
c.
Configure the Frequency and Channel Size the same on all linked radios.
d.
Change the Tx Power, if necessary.
e.
Select Apply & Save All.
f.
Select System Configuration and ensure that each radio has a unique IP address so that they can be
individually accessible over the wireless link.
g.
Change the IP Address.
h.
Select Apply & Save All.
i.
Select New Subscriber Link (or Configuration > Link for SPTP systems) under Provisioning.
j.
Enter a name for the link as well as the unique MAC address of the remote radio if using Normal Links.
Otherwise, ensure that the STID and STID Password match those on the SS radio if using Link
Templates.
k.
Select Apply.
l.
Perform the Link Configuration for any other subscriber links, if using Normal Links or multiple Link
Templates.
m. Select Save All in the Navigation Menu once all links are added.
STID Password defaults to "default".
NOTE
RF-7800W
SYSTEM INSTALLATION
2-3
- Quick Links:
- System Description
- Poe Injector Kit
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
