Compressor; Capacitor; Condenser; Evaporator - Whirlpool Multibras ARC8140IX Service Manual

6.3 – Compressor:
This model is fitted with Embraco Compressor's, which is prepared to work only with the R-600a Fluid
and can only be replaced with another of the same type.
Description
Embraco – EGM90CLC
The Electronic Control System of the product holds a safety device that allows the compressor to be
turned on 7 minutes after its last power down
while the inner pressures of the system are not equalized yet. The same will happen (Safety) if the
Defrost Sensor informs to the Electronic Control temperatures lower than –40
6.4 – Capacitor:
6.5 – Condenser:
This refrigerator holds a new concept of built-in Condenser, which is
known as the "clinched".
To test leakage, install a gauge to the inlet or outlet Condenser pipe, close
the opposite side, then inject air pressure or cooling fluid in the system
and follow through the gauge if there are pressure leak. Finding any,
check the solder points and gauge connection to be sure, not been
detected, Condenser may be defective, with leakage. In case of inner
leakage in this part, it will not be possible to replace alone, only together
with the cabinet.
Don't try to adapt an external Condenser into the Cabinet.
6.6 – Evaporator
The suction line in these products is injected (and cannot be individually replaced unless with the whole
cabinet) into the cabinet, being connected to the Evaporator through Lokring connectors.
Suction Line
EPS – Shim
Left
Defrost Heater
Defrost Shield
MSEX0105i – Electronic No Frost Refrigerator Bottom Mount/ Dual Fan - Maestro High
Characteristics
166W – 220-240/50-60Hz
Remark
.
This prevents the Compressor from attempting to start
The ARC8140IX is fitted with 5µF – 380V Capacitor, located on the
electronic control Box fastened to its support .
Its function is help the compressor works efficient and not to execute startup
IMPORTANT
Lokring Connector
o
C (colder).
Defrost
Sensor
EPS – Shim
Right
Thermofuse
27