Table of Contents
Advertisement
Table 30:
Port Login Accept Payload (PLOGI ACC)
Bit
7
Byte
0
0
1
0
2
0
3
0
N_Port Common Service Parameters
4-19
Port Name
20-27
Node Name
28-35
Class 1 Service Parameters
36-51
Class 2 Service Parameters
52-67
Class 3 Service Parameters
68-83
Reserved
84-99
Vendor Version
100-115
Field definitions (listed alphabetically)
Table
number
Class 1 and 2 Service Parameters
30
May be present in the PLOGI frame. The drive returns only class 3 service parameters. Class parameters for all other
classes of service are set to all zeros.
Class 3 Service Parameters
30
Sent by the drive. See Table 26 for details.
LS Command Code (Link Services Command Code)
30
02h
PLOGI ACC.
N_Port Common Service Parameters
30
See Table 24.
Port Name and Node Name
30
Used to identify the device. The device may have multiple Fibre Channel ports with each having a unique Port Name. The
drive is a dual-ported device.
The Port and Node Names in the PLOGI identify the initiator. The drive saves the Port Name of the initiator with the login
parameters. If a change of the Port Name/AL_PA address association is detected during a Port Discovery (PDISC), an
implicit logout occurs (any queued commands for the previous Port Name/AL_PA are discarded, the previous login is
cleared) and a LS_RJT is returned to the initiator.
The Port and Node Names in the PLOGI ACC identify the drive. The drive uses a format for the Port and Node Names
defined as the IEEE extended address. The format is in Table 23.
Vendor Version
30
Vendor-unique. Not supported.
Fibre Channel Interface Manual, Rev. D
6
5
0
0
0
0
0
0
0
0
LS Command Code
4
3
0
0
0
0
0
0
0
0
2
1
0
1
0
0
0
0
0
0
0
0
0
0
0
65
Advertisement
Table of Contents
