Seagate 77767496 Product Manual page 397

Fibre channel interface
Table of Contents

Advertisement

Public loop device
A device with at least one public NL_Port.
Public NL_Port
An NL_Port which can observe the rules of either public or private loop behavior. A public NL_Port may have
open Exchanges with both private and public NL_Ports concurrently.
QoSF
Quality of Service Facilitator.
QoSR
Quality of Service Request.
R_CTL
Routing Control.
R_A_TOV
Resource_Allocation_Timeout value.
R_RDY
Receiver_Ready.
R_T_TOV
Receiver_Transmitter_Timeout Value.
Random Relative Offset
The relationship specified between Relative Offset values contained in frame (n) and frame (n+1) of an Infor-
mation Category within a single Sequence. For a given Information Category i within a single Sequence, Ran-
dom Relative Offset (RO[i]) value for a frame (n+1) is unrelated to that of the previous frame (n). (see Initial
Relative Offset and Continuously Increasing Relative Offset).
RCS
Read Connection Status.
Receiver
1. The portion of a Link_Control_Facility dedicated to receiving an encoded bit stream from a fibre, convert-
ing this bit stream into Transmission Characters, and Decoding these characters using the rules specified
by FC-PH.
2. An electronic circuit (Rx) that converts a signal from the media (optical or electrical) to an electrical retimed
(or nonretimed) serial logic signal.
Receiver overload
The condition of exceeding the maximum acceptable value of the received average optical power at point
-12
to achieve a BER <10
(See FC-PI-2, Section 5.9, Interoperability points, Figure 10, where
Note.
nector).
Fibre Channel Interface Manual, Rev. D
.
g
R = Bulkhead Receiver Con-
g
R
383

Advertisement

Table of Contents
loading

Table of Contents