This command operates the same as the Write (6) command (Section 12.57) except that in the CDB for this
command a four-byte logical block address and a two-byte transfer length may be specified.
This command terminates with a Reservation Conflict status if any reservation access conflict (see Section
12.39) exists, and no data is written.
If any of the following conditions occur, this command terminates with a Check Condition status and the sense
key is set as indicated in the following table. This table does not provide an exhaustive enumeration of all con-
ditions that cause the Check Condition status.
Condition
Invalid logical block address
Target reset since last command from this initiator
Fibre Channel Interface Manual, Rev. D
Sense Key
Volume Overflow. Set the extended sense information bytes to
the logical block address of the first invalid address.
Unit Attention
325