Seagate 77767496 Product Manual page 372

Table 241: Device Self-test mode summary
When
status is
Mode returned
Fore- After the
ground self-test is
complete
Back- After the
ground CDB is
validated
358
How to abort Processing of subsequent
the Device commands while Device Self-test
Self-test is executing
Abort Task task If the command is Inquiry, Report
management LUNs, or Request Sense, process
function normally. Otherwise, terminate with
Check Condition status, Not Ready
sense key, and Logical Unit Not
Ready, Self-test In Progress addi-
tional sense code.
Send Diagnos- Process the command, except as
tics command described in 13.2.3.2.
with Self-test
Code field set
to 100b
Device Self-test failure reporting
Terminate with Check Condition sta-
tus, Hardware Error sense key, and
Logical Unit Failed Self-test or Logi-
cal Unit Unable To Update Self-test
Log additional sense code.
Application client checks Device Self-
test results log page (see 12.10.4)
after the Progress Indication field
returned from Request Sense indi-
cates the self-test is complete.
Fibre Channel Interface Manual, Rev. D