Raypak XTherm 1005A Installation And Operation Manual page 29

NOTE: The XTherm heater is supplied with a vent
connector that MAY require a specific vent starter adapter
to mate to certified Cat IV stainless steel vent materials
(see Table O). This vent starter adapter is supplied by
the vent manufacturer to adapt to the various venting
systems.
NOTE: Installation of a stainless steel vent systems
shall adhere to the stainless steel vent manufacturer's
installation instructions supplied with the vent system.
Please contact the vent manufacturer with any questions.
The XTherm (1005A-2005A) are supplied with an integral Fas-N-Seal vent connector. The installer must use a specific
vent starter adapter (supplied by the vent manufacturer).
Model No.
1005A
1505A
2005A
Model No.
1005A
1505A
2005A
Model No.
1005A
1505A
2005A
*D-15 Vent Terminal MUST be ordered from Raypak.
Table O.
Air Intake Terminal
810003281
810003369
Air Intake Terminal
9614TERM
9814TERM
Air Intake Terminal
2SVEE0690
2SVEE0890
Certified Stainless Steel Terminations and Adaptors - Category IV
NOTE: The following stainless steel vent manufacturers
are certified for use on these heaters. DO NOT use any
manufacturer of stainless steel vent systems not listed
here. M&G Duravent (FasNSeal Vent), Heat Fab (Saf-T-
Vent EZ Seal) and Z Flex (Z-Vent).
M&G Duravent – "Fas-N-Seal"
Vent Terminal
6" Fas-N-Seal
810003282
6" to 3' Lengths
*D-15 8" 8" Fas-N-Seal
(006646) 6" to 3' Lengths
Heat Fab – Saf-T Vent EZ Seal
Vent Terminal Vent Pipe
6" Saf-T vent
9690TEE
6" to 4' Lengths
8" Saf-T vent
9890TEE
6" to 4' Lengths
Z Flex – "Z Vent"
Vent Terminal Vent Pipe
2SVSRTX06
6" to 4' Lengths
2SVSRTX08
6" to 4' Lengths
Vent Pipe Vent Adapter
810003974
810003980
Vent Adapter
9601RYPK
9801RYPK
Vent Adapter
6" Z vent
2SVSA06
8" Z vent
2SVSA08
5601BOI
5601BOI
29