Nokia 7368 ISAM CPE Product Manual page 42

Install a A-020W-A
5
6
7
8
9
10
36
Release 05.08.01 | June 2018 | Edition 01
Connect the power cable to the power connector.
Note — Observe the following:
•
Units must be powered by a Listed or CE approved and marked
limited power source power supply with a minimum output rate of
12 V dc, 1 A. The polarity of the power adapter plug must match the
A-020W-A CPE.
Power up the unit by using the On/Off power switch.
Verify the LEDs and voltage status.
Activate and test the services.
If necessary, reset the A-020W-A CPE.
Note — Resetting the device will return all settings to factory default
values; any configuration customization will be lost.
i Locate the Reset button as shown in Figure 8.
ii Insert the end of a straightened paper clip or other narrow object into the hole in the
Reset button to reset the device.
STOP. This procedure is complete.
3FE-47511-AAAA-TCZZA
7368 ISAM CPE A-020W-A Product Guide
Issue: 01