Table of Contents
Advertisement
DVD/CD-RW drive activity LED: When this LED is lit, it indicates that the
DVD/CD-RW drive is in use.
Drive eject button: Press this button to release a drive from the server.
Power-supply latch: This latch secures the power supply in place.
Reset button: Press this button to reset the server and run the power-on self-test
(POST). You might need to use a pen or the end of a straightened paper clip to
press the button.
Power button: Press this button to manually turn the server on or off.
Rear view
The following illustration shows the connectors and LEDs on the rear of the server.
RXE Management Port connector
System power connectors (1 and 2): Connect the power cords to these two
connectors to provide power to the server.
RXE Expansion Port (B) connector: Connect a remote I/O enclosure to this
connector.
Serial connector: Connect the signal cable for a modem or other serial device to
this connector.
Remote Supervisor Adapter connectors and LEDs: This group of connectors
and LEDs located on the back of the server are used for system management
28
xSeries 450: Installation Guide
System power
System power
connector (2)
connector (1)
SCSI connector
USB 1 connector
USB 2 connector
RXE Expansion Port (B)
connector
Serial connector
Gigabit Ethernet
connectors
RXE Expansion
Port (A) connector
Video connector
Remote
Supervisor
Adapter
connectors
and LEDs
Ethernet
LEDs
Advertisement
Table of Contents
