Table of Contents
Advertisement
5. Follow the instructions that come with the adapter to set jumpers or switches, if
any.
6. Install the adapter:
a. If you are installing a full-length adapter, open the blue adapter guide by
lifting the front edge, as shown in the illustration.
b. Carefully grasp the adapter by its top edge or upper corners, and align it
with the connector on the PCI-X board.
c. Press the adapter firmly into the adapter connector.
Attention:
When you install an adapter, be sure the adapter is correctly
seated in the connector. Improperly seated adapters might cause damage to
the PCI-X board or to the adapter.
d. Push down on the blue adapter guide to keep the adapter steady.
e. Close the tab; then, push down on the blue adapter-retention latch until it
clicks into place, securing the adapter.
7. Connect the internal cables to the adapter.
8. If you have other options to install or remove, do so now.
9. Go to "Completing the installation" on page 21.
Chapter 2. Installing options
13
Advertisement
Table of Contents
