Table of Contents
Advertisement
Chapter 2. Installing options
This chapter provides basic instructions for installing hardware options in your
server. These instructions are intended for users who are experienced with setting
up IBM server hardware. If you need more detailed information, see the Option
Installation Guide on the IBM xSeries Documentation CD.
Installation guidelines
Before you begin to install options in your server, read the following information:
v Read the safety information beginning on page v and the guidelines in "Handling
v Make sure that you have an adequate number of properly grounded electrical
v Back up all important data before you make changes to disk drives.
v The blue color on components and labels indicates touch points, where
v For a list of supported options for your server, go to the ServerProven
Note: Some preconfigured servers have a unique list of supported options. See the
System reliability guidelines
To help ensure proper cooling and system reliability, make sure that:
v Each of the drive bays has a drive or a filler panel and electromagnetic
v Each of the power-supply bays has a power supply installed in it.
v There is adequate space around the server to allow the server cooling system to
v You have followed the cabling instructions that come with optional adapters.
v You have replaced a failed fan as soon as possible.
v You have replaced a hot-swap drive within 2 minutes of removal.
v All microprocessor sockets always contain either a microprocessor baffle or a
v For redundant and hot-swappable operation, the power supplies are connected to
Working inside a server with power on
Your server supports hot-swap devices and is designed to operate safely while
turned on with the cover removed. Follow these guidelines when you work inside a
server that is turned on:
v Avoid loose-fitting clothing on your forearms. Button long-sleeved shirts before
v Do not allow your necktie or scarf to hang inside the server.
v Remove jewelry, such as bracelets, rings, necklaces, and loose-fitting wrist
© Copyright IBM Corp. 2003
static-sensitive devices" on page 10. These guidelines will help you work safely
with your server or options.
outlets for your server, monitor, and any other options that you intend to install.
components can be gripped, a latch moved, and so on.
http://www.ibm.com/pc/us/compat/ on the World Wide Web.
software documentation provided with those servers for more information.
compatibility (EMC) shield installed in it.
work properly. Leave approximately 50 mm (2 in.) of open space around the front
and rear of the server. Do not place objects in front of the fans.
microprocessor and heat sink.
200-240 V ac.
working inside the server; do not wear cuff links while you are working inside the
server.
watches.
®
list at
9
Advertisement
Table of Contents
