Yamaha PW-SE Original Instructions Manual page 26

26
Lock-release ring Lock-release ring
Charging connector
5. Confirm that charging is complete, and then discon-
nect the charging plug from the battery pack.
How to disconnect the plug (see the left figure)
Grasp the lock-release ring.
Pull it out straight.
6. Place the cap of charging inlet on the battery pack's
charging connector.
WARNING
Never handle the power plug, charging plug or touch
the charger contacts with wet hands. This could re-
sult in electric shock.
TIP
• Charging will start automatically.
• If the display unit is turned on while the battery pack is
charging, all normal displays will be shown, including
the battery capacity indicator, but the assist system will
not function.
• When the battery pack is connected to the battery
charger, the battery charger lamp will flash at approxi-
mately 0.2 second intervals to indicate that the battery
pack is being prepared to be charged. Leave it alone
and charging will start normally.
Charging the battery pack removed from
the bicycle
1. Turn the display unit off.
2. Insert the key into the battery lock, and turn it to re-
lease the battery lock.
3. Remove the battery pack.
WARNING
Use both hands when removing the battery pack. Do
not drop the battery pack or subject it to impact. Do-
ing so could cause the battery pack to become hot or
catch fire, resulting in serious injury or property dam-
age.
TIP
How to remove Multi location type battery packs varies
Cap
between bicycles. For more information, see the instruc-
tion manual supplied with the bicycle.
38