Yamaha PW-SE Original Instructions Manual page 17

Display unit (Display A)
The display unit offers the following operations and infor-
mation displays.
2 Power "On/Off"
Each time you press the power switch, the power switches
between "On" and "Off".
When you turn on the power, all of the displays come up.
After that, it transitions to the main riding display.
TIP
• When you turn on the power, the assist mode is auto-
matically set to Standard mode or High-Performance
mode.
• Keep your feet off the pedals when turning on the dis-
play unit. Also, do not start riding immediately after
turning on the display unit. Doing so could weaken the
assist power. (Weak assist power in either of these
cases is not a malfunction.) If you did either of the
above by accident, remove your feet from the pedals,
turn on the power again, and wait a moment (approxi-
mately two seconds) before starting to ride.
2 Displaying and switching the assist mode
You can select the assist mode by using the assist mode
switches (up & down).
The selected assist mode is displayed by the assist mode
indicator.
• When you press the assist mode switch (up), the mode
changes from "OFF" to "+ECO", or from "+ECO" to
"ECO", or "ECO" to "STD", or "STD" to "HIGH", or
"HIGH" to "EXPW".
• When you press the assist mode switch (down), the
mode changes from "EXPW" to "HIGH", or from "HIGH"
to "STD", or "STD" to "ECO", or "ECO" to "+ECO" or
"+ECO" to "OFF".
TIP
• Bicycles equipped with the PWseries SE or PWseries
TE drive unit has no Extra Power mode.
• Further pressing of the assist mode switch will not cy-
cle the assist mode selections.
11
17