Over-The-Top Bracket Mounting; Side-Mount Bracket Mounting - FLIR PTU-D300 User Manual

PTU-D300 User's Manual (v2.19)

3.7.1 Over-the-Top Bracket Mounting

1. Ensure the pan-tilt has been through its calibration (at power up) so that the mounting hub is
in a known home position.
2. Orient the bracket so the horizontal part of the bracket is topmost. When in the proper
orientation, a peg in the bracket will locate into a hole in the D300 mounting hub.
3. Attach the bracket using 6pcs screws.
It is vital that thread lock is used for the bracket mounting screws. The thread
holes in the hub have thread lock applied to them. If the bracket is removed,
you should apply medium strength thread lock to the hub (e.g., Loctite 242).
4. Reset the pan-tilt and ensure that the bracket moves properly through its range of motion.

3.7.2 Side-Mount Bracket Mounting

1. Ensure the pan-tilt has been through its calibration (at power up) so that the mounting hub is
in a known home position.
2. Orient the bracket so the horizontal part of the bracket is bottommost.
3. Attach the bracket using 6pcs screws.
It is vital that thread lock is used for the bracket mounting screws. The thread
holes in the hub have thread lock applied to them. If the bracket is removed,
you should apply medium strength thread lock to the hub (e.g., Loctite 242).
4. Reset the pan-tilt and ensure that the bracket moves properly through its range of motion.
Figure 4: Payload Bracket Mounting
INSTALLATION & INITIAL SETUP
page 9