Advertisement
Basic safety instructions
This manual contains information on the correct operation of the innogy
i
eBox smart (RFID). The innogy eBox smart (RFID) should be operated
and handled according to these operating instructions. The installation
instructions contain detailed information on installation of the product.
Failure to comply with these can compromise its function and safety.
i
Warranty
The following instructions must be heeded for
the warranty in terms of function and safety:
innogy bears no liability for damage resulting from
non-observance of the instructions. Warranty and
liability conditions of the terms of sale and deliv-
ery or any innogy cooperation agreements are not
extended by the following instructions.
The product may only be operated after notice is
taken of the corresponding operating instructions.
The product may only be operated by qualifi ed
skilled personnel who are familiar with the legal
requirements.
The product may only be used for its intended
purpose.
Repair work may only be undertaken by skilled
personnel or appropriately instructed persons.
Additional training is mandatory.
The product may not be converted or modifi ed.
The manufacturer will not bear any liability for
unilateral modifi cations to the product.
Only suitable accessories may be used with the
product.
Only spare parts listed by innogy in the spare
parts catalog and, consequently, approved may
be used for repairs.
We reserve the right to make technical changes
in the context of further development. In addition
to the instructions in this manual, generally appli-
cable safety and accident regulations must be
observed!
Usage
These operating instructions relate to innogy
eBox smart and innogy eBox smart RFID and are
valid for these boxes if installed as described in
the installation instructions.
Intended use
The device is intended for professional use
outdoors. Instructions for charging are applied to
the innogy eBox smart (RFID) above the charging
plug. The operator pledges to maintain this manual
in a permanently legible condition. Knowledge
of these operating instructions is obligatory for
operation of the innogy eBox smart (RFID).
The device is designed exclusively for charging
electric vehicles with a type 2 plug pursuant to
IEC 62196-2 and charging current control via the
pilot signal pursuant to IEC 61851-1. Use for
supplying other devices is not permitted.
General safety instructions
The innogy eBox smart (RFID) is EMC-tested and
meets the requirements of EMC Directive
2014/30/EU and the Low Voltage Directive
2014/35/EU. Instructions in manuals for (mobile/
wireless) communication devices must be observed
when using in the vicinity of (mobile/wireless)
communication devices.
Operating instructions
5
Hide quick links:
Advertisement
